Most St. Louis Park houses went up between 1940 and 1960, and their kitchens and basements have been reworked two or three times since.
Mon–Fri 8am–6pm · Sat 9am–3pm · Eden Prairie-based, no mileage charge inside 30 minutes
Tap a machine for symptoms, the procedure and local notes.
Refrigerator & Freezer Repair$99 finds the fault · price on paper
Washer Repair$99 finds the fault · price on paper
Dryer Repair$99 finds the fault · price on paper
Dishwasher Repair$99 finds the fault · price on paper
Oven, Range & Cooktop Repair$99 finds the fault · price on paperIce Maker Repair$99 finds the fault · price on paperThe run to St. Louis Park starts on Prairie Center Dr, takes Hwy 212 to Hwy 169 north, and leaves 169 at Hwy 7 or Minnetonka Blvd depending on which side of the city called. Hwy 100 splits the city down the middle, so an address in Fern Hill or Minikahda Vista east of it reaches us through the Excelsior Blvd exit, while Texa-Tonka, Aquila and Bronx Park sit closer to 169. The West End, up at I-394 and Hwy 100, is its own world of apartment towers and underground parking. Methodist Hospital on Excelsior Blvd sends us a steady stream of nurses and technicians who want an early or late window that fits a twelve-hour shift, and we hold those slots for them.
Start with the bungalows and ramblers: one and a half stories, a chimney through the middle, laundry in a basement reached by a narrow stair, dryer venting through a glass-block window frame or the foundation. Kitchens were widened in the 1990s and again in the 2010s, so a 30-inch range now sits where a 36-inch one used to, and a dishwasher was shoehorned beside the sink. The West End and the Excelsior Blvd corridor add several thousand rental units with builder-package Whirlpool, Frigidaire and GE sets. St. Louis Park pumps from its own wells and the water is hard with some iron, so scaled dishwasher elements and orange-stained washer tubs are routine. Winter closes up these tight houses for five months and the condenser coils fill with pet hair.
| Appliance | What we see most here |
|---|---|
| Refrigerators | Condenser coils matted with dog hair in bungalows sealed for winter, and West End French-door units with a stalled evaporator fan |
| Washers | Orange iron staining in top-load tubs, and front-loaders in Excelsior Blvd rentals that shake the closet on spin because the shocks are done |
| Dryers | Vents through glass-block basement windows that were never sized for a modern dryer, packed with lint and frozen at the flap |
| Dishwashers | Heating elements chalked over from hard water in units without a softener, plus inlet valves that only half open |
| Ovens & ranges | Bake elements burned through in 1990s electric ranges, and gas igniters worn weak in the remodeled Minikahda Vista kitchens |
| Ice makers | Hollow cubes from scale-restricted fill valves, and modules that stopped harvesting in ten-year-old side-by-sides |
A 1950s rambler kitchen where every glass came out fogged white. The softener had been in bypass since a plumber visited in the fall. The heating element was crusted but tested good; we descaled it, cleared the spray arms, closed the bypass and left the family with a working machine and a bag of salt on the shopping list.
A building manager texted about a French-door unit in a furnished corporate apartment, fridge side at 50 degrees. The evaporator fan had seized. We replaced it from the truck, the tenant signed for the visit, and the owner approved the written price from a phone somewhere in Chicago.
A gas dryer in a walk-in basement started tripping its thermal fuse each January. The vent left through a glass-block window with a four-inch hole that had been packed with lint since the Reagan years. We replaced the fuse and igniter, cleared the run, and fitted a proper hood.
A ten-year-old top-loader left rust-colored streaks on whites and a rumble on spin. Iron in the well water had stained the tub, and the bearing had let go. We named both problems, priced the bearing, and explained what a softener with an iron filter would stop.
$99 diagnostic, folded into the repair you approve · all pricing after the diagnostic, in writing
A St. Louis Park bungalow spends November to April shut tight, and by February the condenser coil under the refrigerator is wearing a sweater of pet hair. The compressor runs hot, the fridge side creeps to 45, and the ice cream goes soft. Frosted evaporators and dead fans are the other regulars. We pull the kick plate and put a meter on the circuit before deciding. Approve the repair and the $99 diagnostic is part of the price on paper; walk away and $99 closes the visit.
| What you notice | What it usually is | What we do |
|---|---|---|
| Runs constantly, not quite cold | Condenser coil choked with hair and dust, or a condenser fan not turning | Clean the coil, test and replace the fan motor, check compressor amps |
| Freezer fine, fridge warm | Evaporator fan failed or a damper stuck closed on the air passage | Test the fan and damper, replace the failed one, confirm airflow to the fresh-food side |
| Ice sheet in the freezer floor | Defrost drain frozen over from a heater or thermostat fault | Clear the drain, test the defrost circuit, replace the open component |
Yes, Samsung, LG, Whirlpool and Frigidaire French-door units are the bulk of West End and Excelsior Blvd calls. Evaporator fans, defrost sensors and ice-maker modules for them ride on the truck, and the property manager approves the written price by text.
Request refrigerator service in St. Louis Park → · Full refrigerator & freezer repair page →
$99 diagnostic, folded into the repair you approve · all pricing after the diagnostic, in writing
Iron in St. Louis Park well water announces itself on laundry day: orange streaks on a white load, a tub that looks rusty when it is only stained. Underneath that, washers here fail the ordinary ways, drain pumps jammed, lid locks dead, shocks worn so a front-loader walks across the basement. We check the pump, the lock circuit and the suspension with a meter and a level. Say yes to the written number and the $99 diagnosis is already inside it.
| What you notice | What it usually is | What we do |
|---|---|---|
| Stops with water in the tub | Drain pump blocked by lint, a bra wire or a child's sock, or the pump has failed | Clear or replace the pump, flush the hose, run a drain and spin test |
| Banging on spin, walks the floor | Worn shock absorbers or suspension rods, sometimes a broken counterweight bolt | Replace the shocks or rods, level the machine, retest at full spin |
| Rust streaks on clothes | Iron in the water staining the tub, sometimes a rusted spider arm behind the drum | Inspect the drum, name the fault, advise on iron treatment and softener salt |
Usually. A drain pump, door lock or set of shocks costs far less than a new machine and installs the same visit. We give the owner one written price by text and a written warranty by email, so the unit is ready for the next lease.
Request washer service in St. Louis Park → · Full washer repair page →
$99 diagnostic, folded into the repair you approve · all pricing after the diagnostic, in writing
St. Louis Park dryers vent through whatever the basement offered: a glass-block window, a hole in the foundation, twenty feet of flexible duct to the side yard. Winter frosts the outlet shut, lint packs the run, the thermal fuse trips and the drum runs cold. Gas and electric fail differently after that, so we meter the igniter, element and thermostats rather than guessing. Our $99 diagnostic rides inside the repair price you approve; decline and $99 is what you pay.
| What you notice | What it usually is | What we do |
|---|---|---|
| Warm at first, then cold | Cycling thermostat or a gas valve coil that fails once hot | Test the coils and thermostat under load, replace the failed part |
| Cold from the start | Thermal fuse open from restricted airflow, or a burned heating element | Replace the fuse or element, clear the vent that caused it |
| Loud grinding when the drum turns | Rollers flat-spotted or an idler pulley bearing gone | Replace rollers, idler and belt together, check the rear seal |
We clear and reconnect the vent as part of a dryer repair and will fit a proper rigid hood in place of a lint-packed window insert when it is a direct swap. A new vent route through the foundation is a different trade, and we will tell you when that is what the house needs.
Request dryer service in St. Louis Park → · Full dryer repair page →
$99 diagnostic, folded into the repair you approve · all pricing after the diagnostic, in writing
Half the dishwasher calls from St. Louis Park begin with glasses that will not come clean, and half of those turn out to be a softener that ran dry or was left in bypass. The scale that follows coats the element and plugs the spray arms; iron adds an orange tint to the tub. The rest are drain faults and latches. We test the machine before blaming the water. When you approve the written price, the $99 diagnosis is folded into it and disappears as a separate charge.
| What you notice | What it usually is | What we do |
|---|---|---|
| Cloudy glasses, gritty film | Hard water past the softener, scaled element and spray arms | Test the element, descale, clear the arms, check the softener bypass with you |
| Puddle at the front corner | Door gasket worn flat or a spray arm hitting a tall pan and spraying the vent | Replace the gasket, correct the rack loading, run a leak test |
| Cycle stops, error on the panel | Drain pump, float switch or a scaled inlet valve | Read the code, meter the part it points to, replace it and complete a cycle |
That is iron in the well water, not rust from the machine. It builds where water sits, on the tub floor and around the sump. A softener with fresh salt keeps most of it out, and a citric-acid cycle clears what is there. If the element or pump has scaled, we handle that.
Request dishwasher service in St. Louis Park → · Full dishwasher repair page →
$99 diagnostic, folded into the repair you approve · all pricing after the diagnostic, in writing
Remodeled St. Louis Park kitchens hold everything from a 1990s coil-top electric range to a new slide-in induction, and the fault list follows the age. Old electrics burn through bake elements; gas ranges lose igniter strength; glass-tops drop a burner; the newer units throw an F-code and lock the door. We measure igniter current and element resistance on the spot. The $99 you spend finding the fault is already counted in the repair price we write.
| What you notice | What it usually is | What we do |
|---|---|---|
| Oven takes forever to preheat | Bake element weak or broken, or a gas igniter too slow to open the valve | Meter the element or igniter, replace it, verify time to 350 |
| F-code and a locked door | Door lock motor, latch switch or a control board fault | Decode the display, test the lock assembly, replace the failed part |
| Burner clicks but will not light | Wet or cracked spark igniter, or a spark module out | Dry and test the igniter, replace the module or electrode |
Yes. Induction faults are usually a failed generator board or a pan-detection sensor, and they show up as one zone dead or a flashing error. We diagnose with the maker's service codes, order the board if it is not on the truck, and return with no second trip fee.
Request range service in St. Louis Park → · Full oven, range & cooktop repair page →
$99 diagnostic, folded into the repair you approve · all pricing after the diagnostic, in writing
St. Louis Park water carries enough minerals that the tiny orifice in a refrigerator ice-maker fill valve closes down over a few years, and the cubes shrink into cloudy shells. An overdue filter speeds it up. In an unheated back porch the fill tube freezes instead. We handle the ice module inside your refrigerator, from valve to mold to ejector. The repair price we write already has the $99 diagnostic inside it, so nothing is added on top.
| What you notice | What it usually is | What we do |
|---|---|---|
| Cubes getting smaller each month | Scale narrowing the fill valve, filter overdue | Time the fill, replace the valve and filter, check water pressure |
| Bin empty, arm in the down position | Module motor failed, or the mold thermostat never calls for harvest | Test the module and thermostat, replace the assembly if needed |
| Ice with a plastic or stale taste | Filter past its life or a bin that has absorbed freezer odors | Replace the filter, clean the bin and chute, purge the line |
Yes. A tenant hosts, the owner approves the written price by text, and the invoice and warranty go out by email. Fill valves and modules for the common Whirlpool, GE, Samsung and LG units are on the truck, so most rental ice-maker jobs close in one visit.
Request ice maker service in St. Louis Park → · Full ice maker repair page →
All of it, both ZIP codes, from Cedar Lake and the Minneapolis line to the Hopkins border at Texa-Tonka. Fern Hill, Minikahda Vista, Sorensen, Lenox, Elmwood, Wooddale, Aquila, the West End and the apartment corridor along Excelsior Blvd all get the same window and the same pricing, with no mileage charge.
Yes. Our earliest window starts at eight on weekdays and the last one runs to six, with Saturday mornings available. Tell us the shift when you call and we will put you in a slot that lands before or after it, with a text when the truck is on the way.
The tenant lets us in and hosts the visit. We text the owner or manager the diagnosis and one written price, wait for approval, do the repair, and email the invoice and warranty. Building access codes and parking instructions go in the notes when you book.
We say so and stop. You owe the $99 and nothing else, and you get a plain explanation of what failed so you can shop with facts. If you choose to repair, that $99 is already part of the written number, never an extra line on top.
Home base · ZIP 55344 · 55346 · 55347
Area page →8 min from the shop · ZIP 55305 · 55343 · 55345
Area page →8 min from the shop · ZIP 55317
Area page →12 min from the shop · ZIP 55424 · 55435 · 55436 · 55439
Area page →12 min from the shop · ZIP 55343 · 55305
Area page →12 min from the shop · ZIP 55420 · 55431 · 55437 · 55438
Area page →Call (763) 342-9995 or send the form. You get a callback with a real arrival window, and a text when the truck is on its way.
The technician tests the machine, names the failed part in plain words, and writes one flat price. The $99 is already inside it.
We stock the parts that actually fail in west-metro homes, so most jobs close the same visit; an ordered part comes back with no second trip fee.
Full test cycle before we pack up, a clean work area after, and a written warranty on the invoice.
15 minutes from the shop, no mileage charge. $99 diagnostic, one written number, written warranty.