An LG French-door squeezed into a 1950s Bloomington rambler kitchen, an LG stacked pair in a lower-level split near Hyland Lake, LG washers by the dozen in the apartments off American Blvd.
Mon–Fri 8am–6pm · Sat 9am–3pm · Eden Prairie-based, no mileage charge inside 30 minutes
Refrigerator & Freezer Repair$99 finds the fault · price on paper
Washer Repair$99 finds the fault · price on paper
Dryer Repair$99 finds the fault · price on paper
Dishwasher Repair$99 finds the fault · price on paper
Oven, Range & Cooktop Repair$99 finds the fault · price on paperIce Maker Repair$99 finds the fault · price on paper
Most of Bloomington was built before LG sold an appliance in Minnesota, so almost every LG machine here is a retrofit. East of France Ave, the 1950s and 1960s ramblers have galley kitchens where an LG counter-depth French-door replaced a thirty-inch fridge and the dishwasher arrived with new cabinets. West of France, around Normandale, Hyland Lake and Bush Lake, the 1970s and 1980s split-levels hold LG front-load pairs in a lower-level laundry with a long vent run to the side yard. Then there is the apartment stock near the Mall of America, where LG stacked units and compact refrigerators were bought a building at a time. Each setting shapes what fails and how we get at it.
Bloomington pumps well water, hard enough that a softener is normal in the houses and rare in the apartments. Where there is no softener, LG inlet valves and dishwasher heaters scale years early, and IE and tE codes follow. Iron is heavier west of Normandale and leaves orange marks in LG washer tubs and on dishwasher racks. Winter matters in the ramblers most: many have an LG refrigerator in an attached garage off Old Shakopee Rd that quits when the space drops toward freezing, and the short dryer vent through the rim joist ices at the flap so an LG dryer flashes d80 by mid-January. We reach it all straight down I-494 from Prairie Center Dr.
| Machine | Common symptom | What it usually is | What we do |
|---|---|---|---|
| Washer | Stacked or lower-level LG stops on OE, drum full, tenant or owner reports a smell | Drain pump clogged with lint and small objects, or pump windings open after years of heavy use | Drain the tub, clear the pump housing and filter, meter the motor, replace the pump, verify a full drain and spin |
| Dryer | d80 in winter, long dry times, lint smell in the laundry | Rim-joist vent iced at the flap, lint packed inside, or a flow sensor giving a false reading | Measure airflow at the dryer, clear ice and reachable lint, test the sensor, tell you if the duct needs a full cleaning |
| Refrigerator | Counter-depth French-door in a rambler kitchen slowly warming | A linear compressor down on capacity, or an evaporator frosted over because the defrost heater or sensor failed | Read compressor amps and temperature split, test the defrost circuit, give a plain answer and check LG coverage |
| Range / oven | LG electric range top element dead, oven slow or F9 code | Burnt surface element or switch, weak bake element, or an oven sensor out of range | Meter the element and switch, test the bake element and sensor, replace the failed part, confirm heat |
| Dishwasher | tE or HE code, cycle runs long, film on glassware in an apartment with no softener | Heater and thermistor scaled over by unsoftened well water | Descale the sump and heater, meter both, replace what fails, tell the owner what the water is doing |
| Ice maker | Slow ice or none, cubes small, fill tube frozen in the garage unit | Scale-choked fill valve, or a fill tube frozen in the garage unit or along an outside wall | Measure fill volume, replace the valve, thaw and insulate the tube, run a full harvest cycle |
| Code | What it means | What we do |
|---|---|---|
| OE | Drain error — the pump did not empty the tub in time | Hand-drain, clear the pump housing and filter, check the standpipe, meter the pump, replace it if failing |
| IE | Inlet error — fill did not reach the water level in time | Confirm building or house supply is open, clean screens, meter the coils, replace a scaled valve |
| UE | Unbalanced — the drum could not be steadied for spin | Level the stacked or lower-level unit, test shocks and hall sensor, replace worn suspension |
| dE | Door error — the lock switch did not register a closed door | Check the stacked door alignment, test the lock switch, replace the assembly when it reads open |
| PE | Pressure sensor error — the water level sensor is not reporting correctly | Check the air hose for a kink or water, test the sensor, replace it if it fails |
| d80 / d90 | Airflow restriction — most of the exhaust path is blocked | Check the rim-joist vent and flap, clear ice and lint, test the flow sensor, rerun a load |
An LG visit in Bloomington adapts to the building. In a rambler east of France we pull the counter-depth refrigerator carefully out of a tight opening; in an apartment near the mall we coordinate with the site office and work around a stacked unit in a closet. The diagnosis is the same: read the stored error, listen to the owner or tenant, then meter the circuit the code points at, from outlet voltage to coil and heater resistance to door lock continuity and pump or compressor current. LG drain pumps, inlet valves, door locks, shocks, flow sensors, thermistors, defrost heaters and ice maker fill valves ride with us, and most Bloomington LG repairs close in one visit. An ordered part comes back at no second trip fee.
For Bloomington landlords and property managers the approval runs by text: the tenant hosts, the owner approves the written number, and the invoice and written warranty arrive by email. Airport, hotel and Mall of America shift workers get early and late windows. We ask the age of the LG machine before writing a price, and if LG or a store plan still covers the failure we tell you and stop; that includes the linear compressor coverage LG extended on many refrigerators. When the work is ours, the $99 diagnostic is already inside the written price you approve, so a yes does not stack it back on. A no means $99 is the total. Pricing follows the meter and lives on paper, and the repair carries a written warranty.
Yes. LG stacked pairs and compact units are common in the buildings near the Mall of America and along American Blvd, and we handle them for owners and property managers. The tenant lets us in, the written price goes to the owner by text, and the invoice and written warranty follow by email. OE drain codes and dE door codes are the usual calls, and both parts are on the truck.
Most Bloomington apartment buildings have no water softener, so hard well water reaches the LG heater and thermistor unsoftened. Scale coats both within a couple of years, cycles run long, and tE or HE appears. We descale the machine, meter the heater and thermistor, and replace what has failed. In a house with a softener, the same symptoms usually mean the softener is out of salt or in bypass.
Yes. The galley kitchens east of France Ave leave little room around a counter-depth LG, and we bring floor protection and pull the refrigerator out square so the flooring and cabinets are untouched. The repair itself, whether a defrost heater, sensor, fan or a compressor evaluation, is the same as in a bigger kitchen, and we put everything back where it was.
Split-levels west of France often vent the dryer from the lower level through the rim joist to a flap at grade, and in winter that flap ices shut while snow drifts against it. The LG dryer measures the restriction and reports d80 or d90. Clear the flap and check the lint screen first. If the code stays we measure airflow, clear the reachable duct and test the flow sensor, which can also fail on its own.
Yes. Bloomington has a large share of people working shifts at MSP airport, the hotels along I-494 and the Mall of America, so we hold early-morning and late-afternoon windows for them. Tell us when you are home and we schedule the LG diagnosis then; if the part is on the truck, the repair is finished in the same window with the written price approved first.
Call (763) 342-9995 or send the form. You get a callback with a real arrival window, and a text when the truck is on its way.
The technician tests the machine, names the failed part in plain words, and writes one flat price. The $99 is already inside it.
We stock the parts that actually fail in west-metro homes, so most jobs close the same visit; an ordered part comes back with no second trip fee.
Full test cycle before we pack up, a clean work area after, and a written warranty on the invoice.
One call starts it: $99 finds the fault, one written number, repair from the truck, written warranty.